Cart 0
2003-2007 Cadillac, Chevrolet, GMC 3-Button Remote / FCC: LHJ011 - ZIPPY LOCKS

2003-2007 Cadillac, Chevrolet, GMC 3-Button Remote / FCC: LHJ011

  • $1950

Save to my Wishlist

Brand New Aftermarket:

  • FCC ID: LHJ011
  • Frequency: 315 Mhz
  • Battery: CR2032
  • Button: Lock, Unlock, Panic
  • Cross Reference: Part # 21997127, 15132197 #1, 15132198 #2, 10377295, 22730827, 15186203, 15186200 #1, 15186201 #2


  • 2003 - 2007 Cadillac Escalade
  • 2003 - 2007 Chevrolet Avalanche
  • 2003 - 2007 Chevrolet Silverado
  • 2007 - 2007 Chevrolet Silverado Classic Body Style
  • 2003 - 2007 Chevrolet Suburban
  • 2003 - 2007 Chevrolet Tahoe
  • 2003 - 2007 GMC Sierra
  • 2003 - 2007 GMC Yukon
  • 2003 - 2007 Hummer H2

On-board Programming: Yes

NOTE: 07 is split year - please verify

Not all vehicles have on-board programming.

Programming Instructions: You must have all remotes including working ones when performing this procedure. 1. Close all doors. 2. Insert key into the ignition. 3. Press and hold the power UNLOCK button on driver's side door panel. Do not release until instructed to do so in step 5. 4. Quickly turn the ignition ON, OFF, ON, OFF. (ON is the position just shy of starting your vehicle, OFF is the position where you can remove your key) 5. Release the power unlock button on the driver's side door panel. The vehicle should respond by locking and unlocking automatically. If locks cycle then continue to step 6.(if the door locks begin to lock and unlock BEFORE releasing the unlock button then the vehicle has not entered programming mode and you must start over. Remove key, open door and return to step 1. If the vehicle continues to lock and unlock before releasing the unlock button then there is a problem with the vehicles system and remotes must be programmed by a certified professional. If you are unable to get the door locks to cycle then you are turning the key too quick, too slow, there's a problem with the vehicles system, or the vehicle is not equipped with a factory keyless entry system. 6. Hold the LOCK and UNLOCK buttons on the remote at the same time until door locks cycle again. This could take up to 30 seconds. 7. NOW repeat step 6. for all additional remotes including working ones. 8. After step 6. has been performed for all remotes TURN ignition to ON to exit programming mode. 9. Turn ignition to OFF, remove key and test all remotes.

We Also Recommend

Net Orders Checkout

Item Price Qty Total
Subtotal $0.00

Shipping Address

Shipping Methods