Cart 0

2002-2018 Nissan / Infiniti Keyless 3 button Remote FCC: KBRASTU15, CWTWB1U415, CWTWB1U733, CWTWB1U821

  • $950

Save to my Wishlist

  • Nissan / Infiniti Keyless 3 button Remote
  • AFTERMARKET ONLY IS COMPATIABLE WITH P/N: KBRASTUS15, , 28268-5W500, 28268-5W501, 28268-7Z800, 28268-C990A, 28268-EA000, 28268-EA00A, 28268-ZT03A
  • Battery: CR2025
  • Reusable: Yes
  • Frequency: 315 MHz
  • Buttons: Lock, Unlock, Panic
  • NOTES: Will Only Work For Standard Ignition, Not Push Button/Twist Knob Start Systems
  • Refurbished and Aftermarket Remotes MAY Not Have Logo


  • 2003 - 2008 Infiniti FX35
  • 2003 - 2008 Infiniti FX45
  • 2002 - 2004 Infiniti QX4
  • 2004 - 2015 Nissan Armada
  • 2002 - 2016 Nissan Frontier
  • 2003 - 2008 Nissan Murano
  • 2012 - 2017 Nissan NV1500, NV2500, NV3500
  • 2002 - 2013 Nissan Pathfinder
  • 2004 - 2015 Nissan Titan
  • 2007 - 2012 Nissan Versa
  • 2002 - 2015 Nissan Xterra 
  • 2005 - 2010 Nissan Quest
  • 2011 - 2013 Nissan Juke "S"
  • 2008 - 2013 Nissan Rogue
  • 2014 - 2015 Nissan Rogue Select (USA)

Programming Instructions:

IMPORTANT: Before entering programming mode, have in possession all of the transmitters
you will be using on the vehicle. Once you program the transmitter, all previous codes will
be erased from the memory. The other transmitters will not be functional until you program
the transmitters again. 

1.   Close and lock all doors with the driver’s side power lock/unlock switch.

2.   Insert key into ignition and remove it from the ignition key cylinder at least six times
     within 10
seconds. Your
Hazard Lamps will flash if you have performed this step
     successfully. NOTE: Withdraw key completely from
ignition cylinder
each time. If this
     procedure is performed too fast, system will not enter programming mode.

3.   Insert key into the ignition cylinder and turn to the ACC position.

Within 5 seconds, push ANY button on the remote transmitter. Your Hazard Lamps should
NOTE: Do not press 
the button more than one time in the above step. If the button
     is pressed more than one time, the programming
procedure will not be successful.

5.   If there are any remaining transmitters (including the old ones), unlock then lock all doors
     using the
driver’s side
power lock/unlock switch and within 5 seconds, push ANY button
     on the next remote. Your Hazard
Lamps should 
flash. Repeat this step for each
     transmitter (including any existing transmitters).

6.  Turn the key to the OFF position, remove keys from the ignition, unlock doors using the
    driver’s side power lock/unlock switch and open the driver side door.


We Also Recommend

Net Orders Checkout

Item Price Qty Total
Subtotal $0.00

Shipping Address

Shipping Methods